Hot-Dip Galvanized Cable Pulling Sock for 12-150mm Cables with 10-30KN Rated Load

Cable Pulling Socks for 12-150mm Cables Rated 10-30KN

Product Overview

Pulling a power cable is where most jacket damage happens — unless the pull point grips evenly. The SWL sock solves this with a high-tensile steel weave that wraps the cable 360 degrees, holding diameters from 12mm to 150mm at working loads of 10-30KN. A reinforced collar anchors the weave where it meets the pulling line, and the hot-dip galvanized finish stands up to coastal atmospheres. Contractors reach for it at overhead terminations, substation hook-ups, underground pulls and emergency repairs.

Technical Specifications

Applications

· Terminating overhead line cables

· Connecting cables at substations

· Pulling cable through underground ducts

· Temporary fixing during outage repairs

Product Advantages

· 360 Degree Interwoven Grip — the steel weave closes around the whole cable circumference with even pressure, so the jacket stays undamaged through the pull.

· 40 Percent Stronger Hold, 30 Percent Faster Fit — compared with conventional connectors the grip is 40 percent stronger while rigging takes 30 percent less time.

· High-Tensile Steel with Reinforced Collar — the collar takes the pulling strain and keeps the connection firm for 12-150mm cables.

· Hot-Dip Galvanized Protection — the anti-corrosion coating is made for salt air, humidity and years of outdoor service.